BlueOptics 00YL634-BO InfiniBand optický kabel 1 m SFP+ samec/samec

The BlueOptics 00YL634-BO InfiniBand fibre optic cable is a 1 m active optical cable with SFP+ male-to-male connectors designed for high-speed short-range links. It supports 10G multi-mode optical transmission and implements SFP+ electrical and optical interfaces according to MSA standards, providing a compact pre-assembled optical connection for switches, routers, storage systems and server interconnects in data centers and high-performance computing environments.

Advantages

This 1 m SFP+ AOC delivers low-latency, high-bandwidth data transfer without susceptibility to electromagnetic interference, using integrated transmitters and receivers on each end. Manufactured to MSA compatibility and populated with quality optical and electronic components, the cable is calibrated for reliable signal integrity and long operational life. The pre-assembled optical link eliminates the need for field-terminated fiber patching and reduces insertion losses associated with separate transceivers and patch cords.

Key specifications

• Connector type: SFP+ male to SFP+ male (active optical cable)
• Length: 1 metre
• Protocol support: 10G Ethernet and compatible 10G optical protocols
• Fiber type: multimode optical transmission (AOC with integrated transceivers)
• Compliance: MSA-compatible SFP+ form factor and pinout
• Digital diagnostics support: DDM/DOM compatible (subject to host support)
• Use case: short-reach optical interconnects inside racks and between adjacent racks

How to use

Install the BlueOptics 00YL634-BO by inserting each SFP+ connector into the corresponding SFP+ port until the module latches. Ensure the host devices are powered and that firmware/hardware support for SFP+ AOCs and DDM/DOM is enabled if diagnostic monitoring is required. No additional patch cords or transceiver modules are needed; the cable provides a plug-and-play optical link. For best performance, handle connectors by the module housing and avoid contaminating the optical interfaces.

Recommendations

Verify hardware compatibility with SFP+ AOCs on your switch or server model and enable DDM/DOM in the host if you require diagnostic telemetry. Keep the cable run within recommended bend radii, protect connector endfaces from dust, and store unused modules with protective caps. For critical installations, test the link under load to confirm expected throughput and monitor diagnostics for optical power and temperature.