SFP+ optický transceiver CBO MTB-LB10 10Gbps

CBO MTB-LB10 is an SFP+ fiber optic transceiver that supports 10Gbps data rates and is intended for optical network links in switches, routers and servers. The module fits standard SFP+ slots and provides single-mode fiber connectivity to extend link distance, create 10 Gigabit uplinks or replace existing optical modules in enterprise and data centre networks. The design focuses on compatibility with SFP+ form-factor interfaces and straightforward installation into compatible network equipment.

Advantages

The SFP+ transceiver supports 10Gbps throughput with low power consumption and compact SFP+ form-factor. It enables cost-effective extension of network reach over fiber and is suitable for hot-swap replacement without shutting down the host device. Built for interoperability with common SFP+ ports, the module provides optical link stability and predictable performance for high-speed LAN and data centre applications.

Suitable for

• Creating 10 Gigabit uplinks between switches and routers
• Connecting servers to optical aggregation or distribution layers
• Extending network reach over single-mode fiber
• Replacing faulty or incompatible SFP+ optical modules

Key specifications

• Interface: SFP+ form-factor for 10Gbps optical links
• Data rate: 10 Gigabits per second
• Media type: single-mode fiber compatibility
• Connector type: duplex LC optical connector
• Power characteristics: low-power SFP+ transceiver class
• Operating environment: designed for standard networking equipment operating conditions

How to use

Insert the transceiver into a compatible SFP+ slot until it latches, then connect duplex LC fiber patch cables between devices. Ensure transceiver and host device support matching data rate and wavelength characteristics. After insertion, verify link status through the host device management interface and monitor optical levels and alarms where available. For hot-swap replacement, remove the existing module and install the new transceiver while observing ESD precautions and manufacturer guidelines for handling optical components.

Recommendations

Use single-mode duplex LC patch cables with appropriate attenuation and length for the required link distance. Confirm compatibility with the switch or router vendor for SFP+ modules if the network equipment enforces vendor checks. Store unused transceivers in protective caps and anti-static packaging, and avoid touching the optical ferrule to maintain signal quality.