SFP+ optický transceiver CBO MTB-LA10 10Gbps

The SFP+ Fiber Optic Transceiver CBO MTB-LA10 10Gbps from BlueOptics is a small form-factor, hot-pluggable module that delivers 10 Gbps data transmission over single-mode or multimode fiber when used in compatible SFP+ ports. Designed for installation in switches, routers and servers, the transceiver supports high-speed uplinks and point-to-point links in data centers, enterprise LANs and telecom environments. Its compact pluggable design enables straightforward replacement and expansion without powering down equipment.

Advantages

The transceiver provides a standardized SFP+ form factor for broad compatibility with networking equipment that accepts SFP+ modules. It supports 10 Gbps line rate for bandwidth-intensive applications and allows hot swapping to minimize maintenance downtime. The fiber optic interface ensures low-latency, high-throughput links over extended distances compared with copper cabling, and the compact module conserves space in dense networking racks.

Suitable for

• 10 Gbps uplinks between switches and aggregation devices
• Interconnects between servers and storage arrays in data centers
• Carrier and telecom fiber links requiring SFP+ modules
• Network expansions and replacements where hot-pluggable modules are required

Key specifications

• Nominal data rate: 10 Gbps
• Form factor: SFP+ (small form-factor pluggable plus)
• Optical medium: fiber optic (single-mode or multimode, depending on fiber and link design)
• Interface: SFP+ electrical connector for host equipment
• Hot-pluggable design for in-service replacement
• Typical use: uplinks, server-to-switch, switch-to-switch links

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on a switch, router or server until it latches, then connect the appropriate fiber optic cable (LC connector or other matching connector type) between transceivers on both ends of the link. Verify link status via the host device LEDs or management interface and configure interface settings such as duplex and speed as required by the equipment. To remove the module, disengage the latch mechanism and pull the transceiver straight out; handle fiber connectors with care and replace protective dust caps when not connected.

Recommendations

Use factory-tested fiber cables and check compatibility with the host device vendor's supported transceiver list. Match fiber type (single-mode or multimode) and connector type across the link, keep transceiver and cable dust-free, and monitor link status through the network equipment for optimal performance.