XFP transceiver modul BlueOptics 3855-BO optický 10000 Mbit/s

The BlueOptics 3855-BO XFP transceiver module is designed for fiber optic networks requiring a 10 Gbit/s interface. This compact module supports an XFP interface and a maximum data transfer rate of 10000 Mbit/s. Its silver metal housing and lightweight construction (approximately 20 g) make it suitable for high-density networking equipment where space and weight matter. The module meets CE, FCC and RoHS standards and has a rated mean time between failures (MTBF) of 1,000,000 hours.

Advantages

The transceiver provides a standardized XFP interface for compatibility with a range of switches and routers supporting XFP ports. With a maximum throughput of 10000 Mbit/s it supports high-bandwidth applications over fiber. The silver metal casing offers mechanical stability and helps with heat dissipation while the low weight contributes to easier handling and installation. Compliance with CE, FCC and RoHS ensures regulatory conformity for many deployment environments.

Suitable for

• 10 Gbit/s fiber optic uplinks between switches and routers
• Data center and telecom transport links requiring XFP modules
• High-density networking environments where compact transceivers are needed
• Replacing or upgrading existing XFP fiber connections

Key specifications

• Interface type: XFP
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Product colour: Silver
• Weight: 0.02 kg (approx. 20 g)
• Mean time between failures (MTBF): 1,000,000 hours
• Compliance: CE, FCC, RoHS

How to use

Install the BlueOptics 3855-BO XFP transceiver into a compatible XFP port on your switch, router or optical line card according to the equipment manufacturer's instructions. Ensure fiber connectors and patch cords are clean and properly rated for the link type. After insertion, configure the network device as required for the 10 Gbit/s link and verify optical levels and link status through the host equipment management interface. Follow hot-plug handling procedures if supported by the host device.

Recommendations

Use single-mode or multimode fiber and connectors that match the transceiver and link design; verify host device compatibility with XFP modules before deployment. Maintain clean optical interfaces and monitor link parameters from the managing equipment to ensure stable 10 Gbit/s operation.