Vláknový kabel EFB Elektronik O0361.2 2 m

The EFB Elektronik O0361.2 2 m fibre optic cable provides a single-mode OS2 connection with LC and ST connectors in a 2 metre length. Designed for full duplex communication, the cable has a 9 µm core diameter suited for long-range, low-loss optical transmission. It is intended for use in network installations where precise, low-attenuation signal transfer is required between devices equipped with LC and ST interfaces.

Advantages

This fibre optic cable combines the low-loss characteristics of OS2 single-mode fibre and a 9 µm core diameter with the convenience of LC and ST connector types. The 2 m length reduces excess slack in rack and cabinet installations while supporting full duplex links for simultaneous bidirectional data transfer. The termination types make the cable compatible with a wide range of networking equipment, allowing stable and consistent optical performance.

Suitable for

• Connecting single-mode network equipment with LC and ST ports
• Data centre patching and cabinet-to-equipment links
• Telecommunications and long-distance optical links within buildings
• Lab and testbench setups requiring precise single-mode connections

Key specifications

• Fibre type: Single-mode OS2
• Core diameter: 9 µm
• Connectors: LC to ST
• Length: 2 m
• Mode: Full duplex
• Typical use: Low-attenuation, long-reach optical transmission

How to use

Inspect both connector ends and the mating ports for dust or damage before making a connection. Align the LC and ST connectors with their respective ports and insert until the connectors engage securely; ensure any latching mechanisms are properly seated. Route the cable to avoid sharp bends (observe minimum bend radius for single-mode fibre) and secure it to prevent strain on the terminations. For removal, disengage any latch and withdraw straight from the port to avoid damaging the ferrule.

Recommendations

Keep connector endfaces clean using appropriate fibre cleaning tools and caps when not in use. Avoid tight bends and excessive pulling force; follow installation best practices for single-mode OS2 fibres to maintain signal integrity and minimize insertion loss.