Šroubovací bit Bosch 2 608 522 326, 7 ks

The Bosch 2 608 522 326 screwdriver bit set contains seven precision bits with Phillips, Pozidriv and Torx tips designed for general fastening tasks. Each bit has a 1/4" (6.35 mm) hex shank for compatibility with quick-change chucks, bit holders and most cordless and corded drivers. The set is intended to deliver consistent fit, reliable engagement and durability across frequent professional and DIY applications.

Advantages

The bits are manufactured to tight tolerances to ensure accurate tip geometry and reduced cam-out during use. Hardened steel construction provides resistance to wear and deformation under typical torque loads. The standard 1/4" hex shank allows rapid bit changes and wide compatibility with driver accessories. The compact set composition covers common screw profiles for assembly, repair and maintenance tasks.

Suitable for

• Assembly and disassembly of furniture and fixtures
• Electrical and electronic component fastening where Phillips, Pozidriv or Torx screws are used
• General maintenance and repair work in workshops and on-site
• DIY projects requiring a compact selection of commonly used bits

Key specifications

• Number of pieces: 7
• Tip types: Phillips, Pozidriv, Torx
• Shank size: 1/4" (6.35 mm) hex
• Material: hardened steel (wear-resistant bit construction)
• Intended use: manual and powered screwdrivers, bit holders, impact drivers (check compatibility)

How to use

Select the bit with the matching tip profile and seat it fully into the driver or bit holder. Ensure the bit engages the screw head squarely before applying torque to reduce the risk of stripping. For powered drivers, start at low speed and moderate torque, increasing as needed once the bit is properly seated. Replace any bit that shows significant wear or tip deformation to maintain secure engagement and prevent damage to screw heads.

Recommendations

Use the appropriate tip type for the screw head and avoid excessive torque beyond the bit or fastener rating. Store bits in a dry place and inspect tips regularly; worn or rounded tips should be replaced to preserve fastening quality and safety.