SFP transceiver modul BlueOptics E1MG-100FX-OM-FY-BO 155 Mbit/s

The BlueOptics E1MG-100FX-OM-FY-BO SFP transceiver module is a fiber-optic 100BASE-FX compatible unit designed for multimode fiber links with a maximum data transfer rate of 155 Mbit/s. Housed in an aluminium enclosure and weighing approximately 20 g, the module follows MSA SFP form-factor conventions and uses an LC duplex optical connector for send and receive channels. It is intended for use in networking equipment that supports SFP-based optical transceivers.

Advantages

This SFP transceiver provides standardized SFP compatibility and a compact aluminium housing for durability and heat dissipation. It supports optical transmission at 1310 nm wavelengths for both transmit and receive paths and is suitable for multimode fiber links over short distances. The module's lightweight construction simplifies installation and replacement in switches, routers and other SFP-capable hardware while maintaining industry-standard mechanical and optical interfaces.

Suitable for

Key specifications

How to use

Insert the SFP transceiver firmly into an empty SFP slot of a compatible switch, router or other network device while the device is powered down or following the vendor's hot-swap instructions. Connect an LC duplex multimode fiber patch cable to the module, ensuring correct orientation of transmit and receive fibers. Configure the host device interface for 100BASE-FX operation if required by the equipment, and verify link status and speed through the device management interface. If the platform supports digital diagnostics monitoring (DDM/DOM), enable or query it to monitor module parameters.