SATA kabel samec/samec DeLOCK 82822 0,7 m žlutý

The DeLOCK SATA Cable (0.7 m) with male connectors on both ends supports the SATA 6 Gb/s standard and is intended for internal connections between SATA devices such as HDDs, SSDs, controller cards or flash memory. The cable is downward compatible with earlier SATA versions while providing the maximum transfer rate supported by the connected devices. The product comes in yellow and has metal clips on the connectors to ensure a secure snap-in.

Advantages

This SATA cable supports data transfer rates up to 6 Gb/s and is compatible with previous SATA generations. The metal clips on the connectors provide additional retention for stable internal connections. With a length of 0.7 m the cable is suitable for typical internal PC routing and the dual male SATA connectors enable straightforward device-to-device connections.

Suitable for

• Connecting internal hard drives (HDD) and solid-state drives (SSD)
• Connecting SATA controller cards to storage devices
• Internal connections to SATA-based flash memory devices
• PC builds and upgrades requiring a 0.7 m SATA cable

Key specifications

• Interface: SATA 6 Gb/s (backward compatible)
• Connectors: SATA male to SATA male
• Cable length: 0.7 m
• Color: Yellow
• Retention: Metal clip on connectors
• Brand / MPN: DELOCK / 82822

How to use

Power off the system and disconnect it from the mains before installing. Insert one male SATA connector into the SATA port of the motherboard, controller card or device, and insert the other connector into the storage device’s SATA port until the metal clip snaps in to secure the connection. Reconnect power and boot the system; the connected device should be recognized by the operating system. If using older SATA devices, achievable transfer speed will be limited by the lower-generation device.

Recommendations

For reliable operation route the cable away from high-power or high-interference components, avoid sharp bends, and ensure the metal clips are fully engaged. Use the 0.7 m length for standard internal layouts; choose a longer cable if additional clearance is required.