Optický transceiver modul BlueOptics S+32LC10D-BO SFP+ LC hliník

The BlueOptics S+32LC10D-BO is a fiber optic SFP+ transceiver module designed for 10 Gbit/s optical links. It uses an LC simplex connector and an aluminum housing, combining compact SFP+ form factor compatibility with single‑mode fiber transmission. The module implements a bidirectional 10GBASE‑BX‑D optical interface with separate transmit and receive wavelengths for simple fiber runs up to the supported distance, and it weighs approximately 20 g for easy installation in compatible networking devices.

Advantages

This transceiver follows MSA SFP+ mechanical and electrical standards and is manufactured to provide compatibility with devices that support the original S+32LC10D interface. Its aluminum enclosure offers durable protection while maintaining a low weight. The module supports digital diagnostic monitoring (DDM/DOM) for real‑time measurements such as supply voltage, laser bias current, optical transmit and receive power, and temperature when the host hardware exposes these diagnostics. Components are selected to deliver a long operational lifetime and consistent optical performance for Ethernet and related high‑speed protocols.

Suitable for

Key specifications

How to use

Install the BlueOptics S+32LC10D-BO into any compatible SFP+ slot on switches, routers or network appliances that accept standard SFP+ transceivers. Connect an LC simplex single‑mode fiber patch cable to the module and to the remote transceiver or patch panel. Ensure the host device firmware and hardware support bidirectional 10GBASE‑BX‑D operation and, if needed, enable or read DDM/DOM values from the host management interface for status and diagnostics. Handle the module with ESD precautions and keep protective dust caps in place when the transceiver is not connected.

Recommendations

For reliable links, use quality single‑mode fiber patch cords and ensure the remote transceiver supports the corresponding wavelengths and 10GBASE‑BX‑D protocol. Verify host compatibility and test the transceiver in your environment before deployment if the device vendor requires interoperability validation.