Optický transceiver modul BlueOptics ONS-SI-155-I1=-BO 155 Mbit/s SFP

The BlueOptics ONS-SI-155-I1=-BO is a fiber optic SFP transceiver module designed for optical networking links with a maximum data transfer rate of 155 Mbit/s. The module is implemented in a small form-factor pluggable (SFP) housing with an LC duplex optical interface and a silver housing. It supports multimode fiber transmission at 1310 nm for both transmit and receive functions and is intended for integration into network equipment that accepts SFP modules. The product complies with CE, RoHS and FCC requirements and weighs approximately 20 g.

Advantages

The BlueOptics transceiver follows MSA SFP form-factor conventions for straightforward interoperability with compatible switches, routers and storage devices that accept 100BASE-FX SFP modules. Its multimode 1310 nm optical interface provides bidirectional data transmission over LC duplex fiber, enabling simultaneous send and receive on separate fibers. Compliance with CE, RoHS and FCC standards ensures regulatory alignment for typical deployments. The compact SFP format and a lightweight silver housing simplify installation and reduce space requirements in populated networking bays.

Suitable for

• 100BASE-FX Ethernet links over multimode fiber up to typical multimode distances (installation-dependent)
• Interconnecting switches, routers and storage systems that support SFP 100BASE-FX modules
• Optical uplinks and distribution panels using LC duplex connectors
• Environments requiring standards compliance (CE, RoHS, FCC)

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data rate: 155 Mbit/s
• Optical wavelength: 1310 nm (transmit and receive)
• Connector type: LC duplex
• Fiber type: Multimode fiber
• Housing color: Silver
• Weight: approximately 0.02 kg

How to use

Insert the SFP module into an empty SFP slot on compatible network equipment while the device is powered down or following the vendor’s hot-swap procedure. Connect LC duplex multimode fiber patch cords to the module’s transmit and receive ports, ensuring correct fiber polarity. Configure the host device’s interface settings according to network requirements and verify link status through the equipment management interface or LEDs. If digital diagnostic monitoring (DDM/DOM) is supported by the host, enable or query diagnostics to monitor real-time parameters where available.

Recommendations

Use high-quality multimode LC duplex patch cords and maintain proper cleanliness of fiber connectors to preserve signal quality. Verify compatibility with the target hardware platform and firmware before deployment and follow the equipment manufacturer’s guidance for module handling, electrostatic precautions and hot-swap procedures.