Optický transceiver modul BlueOptics 3FE25774AA-BO SFP 10000 m

The BlueOptics 3FE25774AA-BO SFP 10000 m is a fiber optic transceiver module built for single-mode links up to 10,000 metres. Housed in an aluminium casing and weighing approximately 20 g, this SFP form-factor module provides a compact, industry-standard interface for integration into compatible network equipment. It uses an LC duplex connector and conforms to MSA SFP physical form-factor expectations for straightforward installation in switches, routers and other optical ports.

Advantages

This BlueOptics SFP offers long-reach single-mode operation suitable for extended point-to-point connections while maintaining a small, lightweight aluminium housing. The module is compatible with common MSA-compliant SFP ports and is designed and tested for interoperability with major vendor platforms that support equivalent 1000BASE-LX SFP transceivers. Built with selected optical and electronic components, the transceiver supports digital diagnostics (when the host hardware provides DDM/DOM support) to monitor operating parameters remotely.

Suitable for

• Long-distance optical Ethernet links over single-mode fiber
• Interconnecting switches, routers and storage systems across campus or metro distances
• Replacement or expansion of MSA-compatible SFP ports in network infrastructure

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum transmission distance: up to 10,000 m on single-mode fiber
• Connector: LC duplex
• Optical wavelength: 1310 nm transmitter and receiver (1000BASE-LX class)
• Housing material and colour: aluminium, aluminium-coloured
• Weight: approximately 0.02 kg
• Data rate class: Gigabit Ethernet / 1000BASE-LX compatible
• Digital diagnostics: supported when host hardware implements DDM/DOM (MSA SFF-8472)

How to use

Insert the SFP module into an MSA-compatible SFP slot on the network device until it clicks into place, then secure any retaining latch if present. Connect an LC duplex single-mode fiber patch cable, ensuring transmit and receive are correctly crossed between link endpoints. Power up and check the host device for link status; if the host supports DDM/DOM, monitor supply voltage, temperature and optical power values through the device management interface to verify proper operation. Follow the equipment vendor’s instructions for hot-plugging and firmware compatibility checks.

Recommendations

For optimal performance, use single-mode fiber with low-loss connectors, keep connector endfaces clean, and deploy appropriate patch cords or patch panels. Verify host-device compatibility for 1000BASE-LX SFP modules and enable digital diagnostics only if the network hardware supports the DDM/DOM interface. Store unused modules in protective anti-static packaging to avoid contamination and mechanical damage.