Optický patch kabel LOGON PROFESSIONAL AL5SCSC02I/5I 50/125 multimode SC simplex 2 m

Multimode fiber patch cable LOGON PROFESSIONAL AL5SCSC02I/5I 50/125 µm multimode SC simplex 2 m is a factory-terminated fiber jumper intended for short-distance optical links in LANs, data centers and telecommunication racks. The cable uses a 50/125 µm core/cladding multimode fiber and SC simplex connectors to provide a straightforward single-fiber connection between network devices. With a 2 meter length, this patch cord is suitable for interconnections inside cabinets, between patch panels and active equipment and for local fiber runs where multimode performance and connector compatibility are required.

Advantages

The LOGON PROFESSIONAL multimode patch cable delivers low insertion loss and stable optical performance across short-distance multimode links. Factory-terminated SC simplex connectors ensure consistent connector geometry and reliable mating with standard SC ports. The 50/125 µm fiber core is compatible with common multimode transceivers and passive components used in enterprise and data center environments. The 2 m length balances manageability and reach for typical rack and patch panel layouts.

Suitable for

• Short-distance connections in LAN environments
• Interconnects between patch panels and network switches in data centers
• Connections inside telecommunication racks and server cabinets
• Multimode fiber systems using SC simplex connectors

Key specifications

• Fiber type: Multimode 50/125 µm core/cladding
• Connector type: SC simplex on both ends (factory-terminated)
• Cable length: 2 m
• Configuration: Simplex patch cable
• Intended use: Short-distance optical data transmission

How to use

Route the cable between the SC adapter or equipment port locations, avoiding sharp bends and tight cable ties that could stress the fiber. Insert the SC connector into the corresponding SC adapter or port until it clicks or seats fully. When disconnecting, pull the connector body straight out from the adapter or port to avoid bending the cable near the connector. For best results, inspect connector endfaces for contamination and clean them with appropriate fiber cleaning tools before mating.

Recommendations

Store and handle the multimode patch cable following standard fiber optic practices: maintain minimum bend radius as recommended by the manufacturer, keep connectors capped when not in use, and perform endface cleaning to maintain low insertion loss and reliable connections in LAN and data center installations.