Solární regulátor nabíjení KEMO Dual 16 A [ M174 ]

Solar charge controller KEMO Electronic for 12V panels and up to 2 batteries.

• With LED indicator lights

Connected between a 12 V/DC solar panel and 1 or 2 batteries to prevent overcharging. If 2 batteries are connected, they are charged separately. The battery with the lowest charging voltage always receives more charging current. With LED indicators + high charging capacity: max. 2 x 8 A or 1 x 16 A

• Description (PDF document, 339 KB)
• Important mounting note: Depending on the load, the module may heat up more or less. The heat is generated at the aluminum plate on the bottom of the module and, according to the installation instructions, must be cooled under certain circumstances by mounting it on a cooling surface. It is important that the module is mounted flat onto a cooling, flat cooling plate with 4 screws M3 or self-tapping screws 2.9 mm. This can also be the back wall of a metal housing. It is important that the aluminum underside of the module does not warp! Therefore, you must not use larger screws or drill out the holes on the module. The screw heads must rest on the sheet metal of the module and not on the plastic edge of the module! During mounting, the module must not warp (if the surface is not flat). Reason: On the inside of the aluminum base of the module, the electronic SMD components are soldered directly over a thin insulating layer, and if the aluminum base of the module warps, the solder joints break and the module becomes defective. Please also ensure that the maximum temperature of the base plate specified in the description is not exceeded! Otherwise, a larger cooling plate must be screwed on.