InfiniBand/optický kabel BlueOptics 740-065758-BO 10 m SFP+ samec/samec

The BlueOptics 740-065758-BO is a 10 m InfiniBand/fibre optic active optical cable (AOC) with SFP+ connectors on both ends, designed for high-speed links in data centers and networking environments. It supports 10GBASE-SR class applications over multimode fiber and provides a pre‑assembled SFP+ to SFP+ connection that integrates transmitter and receiver modules in each connector, eliminating field termination and simplifying link deployment.

Advantages

This BlueOptics 10 m AOC is manufactured to MSA-compliant SFP+ specifications and is tested for compatibility with major hardware platforms that accept SFP+ 10GBASE-SR modules. The cable carries both transmit and receive optical modules and supports common high-speed protocols such as Ethernet and Fibre Channel over Ethernet at up to 10 Gbit/s. As an AOC, it delivers immunity to electromagnetic interference, lower latency compared with some copper alternatives, and a factory-assembled connection that reduces installation time and potential connector loss. The product includes digital diagnostics monitoring (DDM/DOM) functionality for real-time reporting of voltage, laser bias current, transmit power, receive power and module temperature when supported by the host device.

Suitable for

• 10 Gbit/s server-to-switch or switch-to-switch links in data centers
• Storage system interconnects and SAN links using Fibre Channel over Ethernet
• High-density top-of-rack and aggregation cabling with SFP+ ports
• Short-reach multimode fiber connections up to 10 meters

Key specifications

• Length: 10 meters
• Connector type: SFP+ on both ends (SFP+ male/male AOC)
• Data rate: up to 10 Gbit/s
• Optical standard: 10GBASE-SR over multimode fiber
• Cable type: active optical cable (pre‑assembled multimode AOC)
• Digital diagnostics: DDM/DOM support (if supported by host hardware)
• Immunity: not susceptible to electromagnetic interference (optical link)

How to use

Install the BlueOptics 10 m SFP+ AOC by inserting each SFP+ connector into the SFP+ ports of the source and destination devices while the devices are powered down or according to vendor hot‑swap guidelines. Verify that the host devices support SFP+ 10GBASE-SR AOCs and, if required, enable or check DDM/DOM monitoring in the device management interface to view real‑time diagnostic parameters. After insertion, confirm link status and appropriate network configuration such as speed and duplex settings via the network equipment’s management console.

Recommendations

Use the cable in multimode fiber SFP+ ports and avoid tight bends or tensile stress; maintain the specified minimum bend radius to preserve optical performance. Confirm compatibility with the target hardware and firmware releases before deployment and consider testing a sample in your environment to validate link behavior and diagnostics.