InfiniBand/optický kabel BlueOptics 3 m SFP+ aqua samec/samec

The BlueOptics InfiniBand/fibre optic cable 3 m SFP+ Aqua colour Male/Male is a 3-meter active optical cable (AOC) with SFP+ to SFP+ connectors designed for high-speed multimode fiber links. It supports 10GBASE-SR class applications and is built to meet MSA SFP+ standards, providing a plug-and-play fiber connection between compatible network devices. The aqua-coloured jacket identifies the multimode AOC in rack environments and helps with cabling organization.

Advantages

This SFP+ AOC provides optical data transmission that is immune to electromagnetic interference and designed for low latency, high-throughput connections up to 10 Gbit/s over the 3 m length. The cable integrates transmitter and receiver modules at each end and includes Digital Diagnostics Monitoring (DDM/DOM) support for real-time monitoring of parameters such as supply voltage, laser bias and output power, received power and temperature where supported by the host device. The pre-terminated design removes the need for field termination, patching or additional fiber cleaning for the link itself.

Suitable for

• Short-reach server-to-switch, switch-to-switch or storage-to-switch links in data centers
• 10 Gigabit Ethernet (10GBASE-SR) connectivity in compatible systems
• Fiber channel over Ethernet or SDH/SONET applications up to 10 Gbit/s where SFP+ AOCs are supported

Key specifications

• Length: 3 meters
• Connector type: SFP+ male to SFP+ male (active optical cable)
• Transmission medium: multimode fiber AOC
• Nominal data rate: up to 10 Gbit/s (10GBASE-SR class)
• Form factor compliance: SFP+ MSA compatible
• Color: aqua jacket for multimode identification
• Monitoring: Digital Diagnostics Monitoring (DDM/DOM) support (host dependent)

How to use

Ensure both devices have SFP+ ports that support active optical cables and any required DDM features. With devices powered according to manufacturer guidance, insert each SFP+ connector into the corresponding SFP+ port until the latch engages. The cable is pre-assembled and requires no additional termination or polishing. Verify link status and speed on the connected devices and consult device logs or the DDM interface for diagnostic values if available.

Recommendations

Handle the AOC by the connector housings to avoid strain on the fiber assembly. Keep the minimum bend radius specified by the manufacturer, avoid tight loops, and route the cable to prevent crushing or sharp bends. Confirm compatibility with the host hardware firmware and enable DDM/DOM monitoring if remote diagnostic data is required.