HP RM2-6436-000CN fixační jednotka

The HP RM2-6436-000CN fuser is designed to restore and maintain reliable printing performance in compatible HP Color LaserJet Pro multifunction printers. It secures toner to paper through consistent heat and pressure, supporting sharp text and vivid color output for office documents, reports and marketing materials. The component is form-fit for HP Color LaserJet Pro MFP M477fnw and M452nw series printers and is intended as a direct replacement part to help minimize printer downtime and preserve print quality over the device’s service life.

Advantages

This fuser provides stable temperature control and even pressure distribution across the media path, which contributes to consistent fusing results and reduced risk of smudging or toner offset. The unit is designed for straightforward installation and alignment inside the printer, helping technicians and end users complete maintenance quickly. By restoring the fusing subsystem to expected operating parameters, the part supports sustained print quality and helps extend the effective uptime of the printer.

Suitable for

• Replacing a worn or failed fuser in HP Color LaserJet Pro MFP M477fnw
• Maintaining print quality in HP Color LaserJet Pro M452nw
• Office environments with moderate to high color printing volume
• Service and repair tasks performed by IT or print maintenance personnel

Key specifications

• Compatibility: HP Color LaserJet Pro MFP M477fnw and M452nw series
• Function: Heating and fusing toner to paper
• Form factor: Internal fuser assembly designed for the specified printer models
• Expected result: Restores consistent fusing temperature and pressure for sharp text and vibrant color output
• Installation: Tool-assisted or tool-free installation depending on printer configuration

How to use

Power off the printer and disconnect it from the mains before beginning any service. Allow the unit to cool if recently used. Access the fuser compartment according to the printer service manual, remove covers or cartridges as needed, and carefully extract the old fuser following manufacturer instructions. Install the replacement fuser by aligning it with mounting guides and securing any latches or screws. Reassemble covers and cartridges, reconnect power and run a printer self-test or calibration page to confirm correct operation and print quality.

Recommendations

Use genuine or specified replacement parts and follow HP service guidelines for disposal of used components. After installation, run a test print and, if available, perform any recommended calibration procedures to ensure color balance and fusing performance. For frequent high-volume color jobs, monitor print output and schedule preventive maintenance to avoid premature wear.