BlueOptics QSFP-AOC-1M-SS-BO InfiniBand optický kabel 1 m samec/samec

The BlueOptics QSFP-AOC-1M-SS-BO InfiniBand fibre optic cable 1m Male/Male is a 1 metre active optical cable designed for high-speed short-reach interconnects. With QSFP form-factor connectors on both ends, this cable supports InfiniBand links and high-throughput data transfer between networking equipment, servers and storage systems where low latency and signal integrity are required.

Advantages

This InfiniBand fibre optic cable provides a compact, low-power alternative to separate transceivers and copper patches by integrating optical transceivers into the cable ends. The one-metre length reduces excess cable management and signal loss in rack and chassis environments. Built to industry connector standards, the cable ensures consistent performance for high-bandwidth links and simplifies installations in dense network topologies.

Suitable for

• High-performance computing (HPC) clusters and InfiniBand fabrics
• Interconnecting switches, routers, servers and storage arrays within racks
• Low-latency data centre links and backend server connections
• Short-reach links requiring QSFP form-factor connectivity

Key specifications

• Cable type: Active Optical Cable (AOC)
• Connector type: QSFP-to-QSFP, male on both ends
• Length: 1 metre
• Application: InfiniBand high-speed interconnects and data centre links
• Transmission: Optical, for reduced electromagnetic interference
• Typical use: Short-reach, high-bandwidth server and switch connections

How to use

Insert each QSFP connector into the corresponding QSFP port on the networking devices until the connector latches. Ensure devices are powered and configured for the InfiniBand link or compatible QSFP interface. Verify link status via device management interfaces and arrange the cable to avoid sharp bends or strain on the connectors. For best signal integrity, use the cable within recommended rack and port layouts and avoid routing near high-heat sources.

Recommendations

Handle the cable by the connector housings, avoid pulling on the fibre section, and maintain a minimum bend radius consistent with industry optical cable practices. For stable performance, keep the length choice appropriate to the rack layout—this 1m cable is intended for short, direct connections inside racks or between adjacent equipment bays.