BlueOptics PAN-QSFP28-AOC-15M-BO InfiniBand optický kabel 15 m samec-samec

The BlueOptics PAN-QSFP28-AOC-15M-BO InfiniBand Fibre Optic Cable 15m Male-Male is a 15-metre active optical cable with QSFP28 connectors on both ends. Designed for short-reach, high-bandwidth links, this AOC supports 100G data rates over multi-mode fibre and provides a direct, vendor-compatible connection between QSFP28 ports in data centre and high-performance computing environments.

Advantages

This active optical cable integrates transmitters and receivers in each connector to enable high-speed optical transmission without external transceivers. The QSFP28-to-QSFP28 male-male configuration simplifies installation and reduces the number of components required for 100G links. Its 15 m length offers flexibility for rack-to-rack or equipment-to-equipment connections while maintaining electrical isolation and immunity to electromagnetic interference.

Suitable for

• High-performance computing clusters and interconnects
• Data centre top-of-rack and spine connections
• Switch-to-switch or router-to-switch 100G links
• Storage networking and server interconnects requiring 100G bandwidth

Key specifications

• Connector type: QSFP28 male to QSFP28 male
• Cable type: Active optical cable (AOC) over multi-mode fibre
• Length: 15 metres
• Supported link rate: up to 100 Gbit/s
• Application protocols: Ethernet and related high-speed protocols

How to use

Ensure both devices have QSFP28 ports that support AOC modules and are powered down or in a safe hot-plug state according to the equipment manufacturer’s guidelines. Align the QSFP28 connectors with the device ports and insert firmly until the latch engages. Verify link status through the host hardware or management interface and confirm negotiated speed and link health. To remove, release the connector latch and pull straight out, avoiding excessive bending of the optical cable.

Recommendations

For reliable operation, route the cable to avoid sharp bends and excessive mechanical stress. Use in environments where 15 m reach is sufficient for rack-to-rack or equipment-to-equipment connections. Verify compatibility with the host device firmware and supported link modes before deployment and consider testing a sample in your environment to confirm interoperability.