AOC kabel BlueOptics AOC-QSFP28-CABLE-15M-BO 15m QSFP28 samec/samec

The BlueOptics AOC-QSFP28-CABLE-15M-BO is a 15-meter active optical cable engineered for high-speed data transmission between QSFP28-enabled devices. With QSFP28 male connectors on both ends, this cable supports low-latency, high-bandwidth links commonly required in data centers, network aggregation switches, and high-performance computing clusters. Its active optical design reduces electromagnetic interference and supports stable signal integrity over the 15 m link length.

Advantages

This active optical cable provides high bandwidth and low latency suitable for 100 Gigabit Ethernet and other high-speed interconnects. The QSFP28 connectors on both ends enable direct device-to-device connections without transceivers, simplifying installation and reducing port usage. The optical design offers immunity to electromagnetic interference and lower power dissipation compared with some copper alternatives, contributing to reliable long-term operation in dense networking environments.

Suitable for

• Interconnecting QSFP28 ports in data centres and server racks
• High-performance computing clusters requiring 100 Gbps links
• Switch-to-switch, switch-to-server, and aggregation links
• Environments where reduced EMI and stable long-reach connections are needed

Key specifications

• Interface: QSFP28 male to QSFP28 male
• Cable type: Active optical cable (AOC)
• Length: 15 meters
• Supported data rate: designed for 100 Gbps class links (QSFP28)
• Transmission medium: optical fibre within AOC assembly
• Typical use: short to medium reach interconnects inside facilities

How to use

Install the cable by plugging each QSFP28 male connector firmly into the corresponding QSFP28 port on networking equipment. Ensure the connectors align with the port latch and observe proper handling to avoid bending the cable beyond recommended curvature. The active elements are integrated; no additional transceivers or configuration are usually required on compatible equipment. Verify link status via the host devices after connection to confirm proper operation.

Recommendations

Route the cable along designated cable management paths to avoid tight bends and mechanical stress. Maintain clean connector interfaces and power down ports before insertion or removal if recommended by the equipment vendor. Confirm compatibility with your switches or servers for QSFP28 AOC support and firmware requirements to ensure optimal performance.