Microconnect SFTP702W síťový kabel bílý 2 m Cat7 S/FTP (S-STP)

The MicroConnect SFTP702W RJ-45 Cat7 2m White is a 2-metre high-performance network cable designed for wired Ethernet connections where signal integrity and reduced interference are important. Built to Cat7 specifications with S/FTP shielding, the cable supports higher frequencies and improved crosstalk protection compared with older categories. The white jacket provides a discreet appearance suitable for visible installations in homes and offices.

Advantages

The S/FTP construction combines an overall foil shield with individually shielded pairs to minimise electromagnetic and radio-frequency interference. Cat7-rated transmission characteristics enable reliable high-speed data transfer for modern networks. RJ-45 connectors on both ends ensure compatibility with common switches, routers and network devices while the 2 m length offers flexibility for desktop and rack-mounted setups without excess cable clutter.

Suitable for

• Connecting desktop computers, network printers and NAS devices to switches or routers
• Office and home wired network installations where reduced interference is required
• Short-run connections between patch panels and wall ports in structured cabling

Key specifications

• Cable category: Cat7
• Shielding: S/FTP (overall foil + individually shielded pairs)
• Connector type: RJ-45 to RJ-45
• Length: 2 m
• Colour: White
• Weight: 0.03 kg

How to use

Insert each RJ-45 connector into the Ethernet ports of the devices you want to connect until the clip snaps into place. For best signal quality, avoid sharply bending the cable near the connectors and keep the cable run clear of high-power electrical wiring or strong radio-frequency sources. Use the 2 m length for direct device-to-switch/router connections or for short patch runs in wall-mounted or desk-side installations.

Recommendations

For consistent performance, verify that connected network equipment supports the intended data rates and is properly grounded. If routing the cable through tight conduits or around corners, maintain a minimum bend radius specified by general cabling practice to avoid deforming the internal pairs and compromising shielding effectiveness.